This International Standard specifies a method of tensile testing of metallic materials at a specified temperature greater than ambient temperature and defines the mechanical properties which can be thereby determined.

 The following normative documents contain provisions which, through reference in this text, constitute provisions of this International Standard. For dated references, subsequent amendments to, or revisions of, any of these publications do not apply. However, parties to agreements based on this International Standard are encouraged to investigate the possibility of applying the most recent editions of the normative documents indicated below. For undated references, the latest edition of the normative document referred to applies. Members of ISO and IEC maintain registers of currently valid International Standards.

ISO 286-2, ISO system of limits and fits — Part 2: Table of standard tolerance grades and limit deviations for holes and shafts.

ISO 377, Steel and steel products — Location and preparation of samples and test pieces for mechanical testing.

ISO 2142,  Wrought aluminium, magnesium and their alloys — Selection of specimens and test pieces for mechanical testing.

ISO 2566-1, Steel — Conversion of elongation values — Part 1: Carbon and low alloy steels.

ISO 2566-2, Steel — Conversion of elongation values — Part 2: Austenitic steels.